Slicer Discord
Sand Clock – 3D-Druckmodell von GrabCAD GrabCAD
Autodesk Inventor 2010, CATIA V5, NX Unigraphics 7.5, Pro/Engineer Wildfire R5.0, STEP / IGES

Sand Clock

289 Downloads
31 Likes
0 Makes
Zum Modell
An hourglass (sandglass, sand timer, sand watch, sand clock, egg timer) measures the passage of a few minutes or an hour of time. It has two connected vertical glass bulbs allowing a regulated trickle of material from the top to the bottom. Once the top bulb is empty, it can be inverted to begin timing again. The name hourglass comes from historically common hour timing.[clarification needed][citation needed] Factors affecting the time measured include the amount of sand, the bulb size, the neck width, and the sand quality. Alternatives to sand are powdered eggshell and powdered marble[1] (sources disagree on the best material). In modern times, hourglasses are ornamental, or used when an approximate measure suffices, as in egg timers for cooking or for board games.
Kategorie
Autodesk Inventor 2010, CATIA V5, NX Unigraphics 7.5, Pro/Engineer Wildfire R5.0, STEP / IGES
Quelle
GrabCAD
Veröffentlicht
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STEP, STL
Material
Marble PLA
Nachbearbeitung
Schleifen
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen