Thingiverse
sand excavator support
von Okieh
2
Downloads
4
Likes
0
Makes
I've created this support to mount a sand excavator for my little kids.
It consists of an upper part to support the excavator and a lower part wich keeps it in place.
It is also designed to limit the lateral movement to an angle of 90 degrees to keep the sand inside.:-)
Printing time was about 8 hours with 0,2mm resolution.
It consists of an upper part to support the excavator and a lower part wich keeps it in place.
It is also designed to limit the lateral movement to an angle of 90 degrees to keep the sand inside.:-)
Printing time was about 8 hours with 0,2mm resolution.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!