Sanding block
door Flyerdude
8
Downloads
2
Likes
0
Makes
Sanding block.
Designed for sanding ribbon with a width of 50mm.
It has a flexible part in the top block to enable clamping the sanding ribbon in one side first (the short side seen from the flexible part) tighten the ribbon and then clamp the other side.
You'd need additional two hexagonal biolts M5 x 35 a 40 and two M5 nuts.
The base is printed flat. To ensure a flat face for the sanding ribbon,
The top is printed on its side. To enable a a mechanically sturdier spring.
Designed for sanding ribbon with a width of 50mm.
It has a flexible part in the top block to enable clamping the sanding ribbon in one side first (the short side seen from the flexible part) tighten the ribbon and then clamp the other side.
You'd need additional two hexagonal biolts M5 x 35 a 40 and two M5 nuts.
The base is printed flat. To ensure a flat face for the sanding ribbon,
The top is printed on its side. To enable a a mechanically sturdier spring.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!