Thingiverse
Sanding Block
von rednosed
44
Downloads
19
Likes
0
Makes
Sanding block in two pieces, fixed together (and with a sanding paper) using two printed screws.
Some cut-outs in the design to save on filament.
I don't like supports, so I made it to not need supports to print.
The paper I had at hand was 140mm width. The width of the sanding block is 60mm. The idea is to cut the paper in half, which leaves you 5mm extra paper on each side of the block.
Some cut-outs in the design to save on filament.
I don't like supports, so I made it to not need supports to print.
The paper I had at hand was 140mm width. The width of the sanding block is 60mm. The idea is to cut the paper in half, which leaves you 5mm extra paper on each side of the block.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
