Sanding block

handy little sanding block for regular 50mm emery cloth. Length is about 110mm

You`ll need
1xM8*50 bolt (40 will work but the extra length comes in handy.)
1xM8 washer (you can do it without, but the washer helps sliding the parts smoothly)
1xM8 nut

You`ll wrap the emery cloth around, and it will snug itself up if you twist the knob. If you don`t have enough clearance, you can alsways sand a cunthair off the holding plate. Mine printed without a problem, though I had a slight bed sticking problem. that was my fault.

The knob I printed small end down. so you don`t need supports on that. only supports are for the hex in the base of the sanding block.