Thingiverse
Sanding Tool
von smatkala
4.8k
Downloads
2.8k
Likes
3
Makes
Cut strips of sandpaper (140x10mm).
Insert skrew into washer, then the skrew into the body, then tighten the nutt a little.
place each end of the sandpaper strip under the washer and around the body.
Hold the body with your fingers on the ends, gently press the body together to pre-tension the sandpaper and tighten the nut.
Print with 0.4mm Nozzle and 0.1-0.15mm layer hight and 100% infill.
Insert skrew into washer, then the skrew into the body, then tighten the nutt a little.
place each end of the sandpaper strip under the washer and around the body.
Hold the body with your fingers on the ends, gently press the body together to pre-tension the sandpaper and tighten the nut.
Print with 0.4mm Nozzle and 0.1-0.15mm layer hight and 100% infill.
smatkala veröffentlicht auch auf
2 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
