Sandpaper Dispenser

Sandpaper dispenser, with integrated cutter. I wasn't that happy with any of the dispensers I could find so I designed this. Max sandpaper roll height: 115mm Max sandpaper roll diameter: 65mm Some parts are required: 4x M3 nuts and bolts (5-10mm long - ideally about 5mm not including the head of the bolt)A junior hacksaw blade (these seem to be 5mm wide as standard. The length doesn't matter as it needs to be snapped off anyway). Assembly Put the hacksaw in place (it should have a little metal bar that fits into the retention bar). You can now insert the nuts into the back and screw in the bolts. With the top of the blade clamped in place, you can now clamp the bottom down with another set of nuts/bolts. There is a center hole at this end which will not be filled unless you decide to install the blade the other way around for some reason. The blade will pertrude beyond the base of the holder. Once it is clamped down use a pair of pliers to snap the excess blade off. The nuts ca