Thingiverse
Santaur
por aethersaviator
34
Descargas
33
Likes
2
Makes
This is a remix of Jeremycon's Santa Claus bust and YahooJAPAN's Centaur. Put them both together and you get the ultimate Christmas creature: the Santaur.
Two main versions (.STL's) included: one emblazoned with "SANTAUR" on the side of the base and the other without. I've also included a variation of each with a small loop in the back to be used as an ornament if you're feeling extra festive.
Printing at 100% scale makes a Santaur that's approximately 12.5 cm or 5 inches tall.
Printing the arms without supports is not recommended. I ended up using a support overhang threshold of 70° to keep them in place.
Thanks again to the original designers for their work and I hope you enjoy!
Two main versions (.STL's) included: one emblazoned with "SANTAUR" on the side of the base and the other without. I've also included a variation of each with a small loop in the back to be used as an ornament if you're feeling extra festive.
Printing at 100% scale makes a Santaur that's approximately 12.5 cm or 5 inches tall.
Printing the arms without supports is not recommended. I ended up using a support overhang threshold of 70° to keep them in place.
Thanks again to the original designers for their work and I hope you enjoy!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!