Thingiverse
SAO Night Sky
por Dingezzz
82
Descargas
59
Likes
0
Makes
this file is not tested, but i tested the thicker version and this one you are able to print.
the pommel screws on a M8 thread so you can use this to make the blade stronger over the whole lenght.
the smaller holes next to it are to make alignment easier with assembly.
This is one of two versions i made of the night sky sword from sword art online.
This one has the thin blade it is 1cm thick
i also uploaded a 2cm thick version because nobody knew what looked best.
if someone made it please share it so we can see the differences
it is cut up to fit a CR10S because this is what i use.
https://www.thingiverse.com/thing:3550511
the pommel screws on a M8 thread so you can use this to make the blade stronger over the whole lenght.
the smaller holes next to it are to make alignment easier with assembly.
This is one of two versions i made of the night sky sword from sword art online.
This one has the thin blade it is 1cm thick
i also uploaded a 2cm thick version because nobody knew what looked best.
if someone made it please share it so we can see the differences
it is cut up to fit a CR10S because this is what i use.
https://www.thingiverse.com/thing:3550511
Dingezzz también publica en
38 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
