Sapphire Plus Volcano Mount

This is used with a volcano hotend and it will mount the volcano higher than most other volcano mounts. The tip of the nozzle will be heigher than the rods on which the bed moves. You can use this mount with v6 or mosquito hotends but you will need to put some nuts with the springs in between bed and bed support to raise the bed. I have printed this mount with both 0.3 and 0.2 layer height with 45% giroid infill (probablly cubi will also work) from PETG an it works fine. Only the main body needs supports the other parts should be printable without suports mostly. For belt fixation you need to use this https://www.thingiverse.com/thing:4200490 and for belt tensioning u can use this https://www.thingiverse.com/thing:4246413. It reguires 2 x 30mm m3 nuts and 2 x m3 nuts to screw the hotend with the mount through the main body to the under part used for reinfocement . It also requires 2 x 14mm (or maybe even 16mm) m3 screws with flat head and 2 x m3 nuts to screw the under part used for