Thingiverse
Sarrus Linkage Mark III
von fdavies
92
Downloads
247
Likes
1
Makes
This is the next step in my attempt to make a Sarrus linkage based 3D printer. The idea is to have a cartesian mechanism without those long rods and bearings.
I built three of the Mark III and mounted them in a x-y arrangement as shown. They can move over a square about 105 mm wide, and someday may carry an extruder. They are driven by DC motors taken from inkjet printers. These motors are driven in a servo arrangement using quadrature optical encoders and optical strips removed from the same printers.
I built three of the Mark III and mounted them in a x-y arrangement as shown. They can move over a square about 105 mm wide, and someday may carry an extruder. They are driven by DC motors taken from inkjet printers. These motors are driven in a servo arrangement using quadrature optical encoders and optical strips removed from the same printers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
