SATEC PM172E Replacement Back Panel

This is a replacement back panel for a Satec PM172 power quality meter.

Best printed with an internal dimensions compensation of ~0.1mm using PETG filament.

Insert 4 M3x8mm threaded hex spacers (female-female) into the printed back plate. Screw in the male-female spacers after disassembling the PM172. Carefully re-install the circuit board assembly onto the base assembly. hold the spacers with a wrench and insert the M3 machine screws.

Attach the front panel cable and insert the unit into the main housing, lining up the studs from the front panel. Secure the back panel using the thumb screws.

Ensure the unit powers up on the bench to complete the replacement. After the unit has been successfully powered up, schedule the meter to be tested by your meter department or a third party testing facility prior to returning to service.