SaveGrabber Extended

Hi, just a quick remix in 3d builder. One slice and duplicate of back half, one cylinder added to close holes and create middle bump.

Increases width for turning leverage, adds extra hole for second finger, or optional overhand grip over the two holes instead of inside is now possible with the included bump.

I would seal the print lines with gloss coat, thick gloss paint, or seal it with a flame or heat to help close up micro crevices where germs can sit. And then wash or spray with alcohol after use.

Edit: its an interesting concept, but in use its a little awkward. Also round door knobs for twisting are a challenge this does not quite meet.