sBitx + ATU100 Case

I purchased the board only from HFSignals, so it turned into a 3D printing challenge.

I was inspired by the remixed listed of mark which I found on GroupIO:

https://groups.io/g/BITX20/topic/v1_sbitx_3d_printable_case/103872075?dir=desc

The next challenge was printing it on my new Banbulabs X1C which the bed is shorted by 8mm :-(

So I started to split the models, and as such made some changes to host my different display, add some push buttons and the ATU-100 antenna tuner.

For the antenna tuner, I got the concept from the extremely detailed design of Derk Kenig:

https://www.thingiverse.com/thing:6754805?fbclid=IwY2xjawFOXlhleHRuA2FlbQIxMAABHUPreltPWyZkVBKs6qGBbRn8IxLQo8Vkz6jMf2Kn5aAsvwGTGGl5BlQfcg_aem_mKL1SdQrseia8Pvh-mq38Q

The support legs taken from this great design of Bob:
https://www.printables.com/model/734871-sbitx-tilt-legs-for-portable-operations


Note that the design is for this 7 inch display I purchased on Ali:

7 Inch DSI Touch Screen for Raspb