Slicer Discord
Scalable Snap-Lid Case - No Hardware Needed – 3D-Druckmodell von MakerWorld MakerWorld
Organizers

Scalable Snap-Lid Case - No Hardware Needed

319 Downloads
135 Likes
182 Makes
Zum Modell
This simple snap-lid case fits together with no additional hardware. It can also be easily scaled up in different directions for a custom fit. ScalingAll the model parts are provided in the proper orientation for printing. The nominal case dimensions for the files provided are 32mm tall x 76mm deep x 107mm long. Set the X and Y scale factors to adjust the height and depth of the case. The X and Y scale factors must be the same to keep the case functional. The Z axis scale factor can be set independently to adjust the length of the case. In general, you should be able to scale up by as much as a factor of 2, but I wouldn't recommend scaling this too much smaller as you will run into tolerance issues. AssemblyTake the case bottom and fit one end into the slot in one of the end pieces. It will slide partway in, but then you'll need to gently tap it in the rest of the way using a small mallet. Next, place the lid onto the hinge pin of the partial assembly and snap the lid closed. L
Kategorie
Organizers
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

LoboCNC veröffentlicht auch auf

313 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen