Thingiverse
Scaleable Cap Holder
0
Downloads
0
Likes
0
Makes
# Summary
**Got something that needs holding down?** Got a 90° curve that needs clamping to a flat surface? Print off 3 or more of these and screw them in and it isn't going anywhere!
# Scaling
**This model is a scaleable thing.** The ratio of the arc side length to hole diameter is 10:3 mm. The model as it comes is a 90° arc with side lengths of 10mm and a hole diameter of 3mm.
**Got something that needs holding down?** Got a 90° curve that needs clamping to a flat surface? Print off 3 or more of these and screw them in and it isn't going anywhere!
# Scaling
**This model is a scaleable thing.** The ratio of the arc side length to hole diameter is 10:3 mm. The model as it comes is a 90° arc with side lengths of 10mm and a hole diameter of 3mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!