MakerWorld
Hand Tools
Vai al Modello
Scalpel Case
2
Download
3
Likes
3
Makes
Scalpel case for a #3 handle. Requires no fasteners. Hinge and latch use two 70mm length pieces of 1.75mm filament for the hinge pins. Cut the filament with a slight angle on one end. Feed it through the holes and center it evenly. Use a lighter or torch to heat the ends and flatten. This hinge pin design allow for replacement should the pins become loose. NOTE: Filament diameter may vary. If holes are too tight, passing a #48-50 or 1.8-1.9mm mm drill bit through them will allow for free fit without being too loose.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
