3D Printer Accessories STL Download - Scan Otter Caseby Creating_3d

Creality Cr-Scan Otter Case with handle and lock.The reason I made this model was that I found it a pain to disconnect the connector from the scanner every time it went into the small bag that came with it.That you had to crumple the cord to make room, which causes damage to the cord and wear on the connector.With this hard case I can take the scanner out/in without having to worry about the connector or cord and start scanning right away.No strong bends on the cord that can be damaged.What is needed are 16 small magnets 6mm x 3mm but with the 2 locks you can do without magnets if you want.All accessories for the scanner fit in the bag and the calibration plate has its own small place and sits securely in the compartment that is available.Under the lid is a bracket that can be used to hold the scanner in place when you carry the bag around and the supporting pillar must be made in your own desired length depending on how much stuff you put above the calibration plate.e.g. Manual.The included "pillar" is intended to lie exactly against the plate so the bag can be closed.In the slicer you can split this to the desired length.The handle is screwed on with 2 studs that are made entirely of plastic. (12 socket) and is strong enough to be carried around.Size of bed needed: 320x235 (Made in k2 plus)Infill i ran 10%Bottom and top shell layer 3Normal support