Thingiverse
Scanstrut DS-H10 mounting bracket
door TunnelVision
0
Downloads
0
Likes
0
Makes
Mounting bracket for Scanstrut DS-H10 cable entry with M4 hardware - an alternative to using self-tapping screws.
Requires:
- 4 x M4 nyloc nuts DIN 985 (stainless steel)
- 4 x form A M4 washers DIN 125 (stainless steel)
- 4 x countersunk M4 x 16 screws (stainless steel) (M4 x 12 might work too)
I pressed-in the nyloc nuts with a small ammount of super glue, and used washers on the van roof side, also with some super glue.
Double-sided tape holds the bracket in place ready for the screws.
Requires:
- 4 x M4 nyloc nuts DIN 985 (stainless steel)
- 4 x form A M4 washers DIN 125 (stainless steel)
- 4 x countersunk M4 x 16 screws (stainless steel) (M4 x 12 might work too)
I pressed-in the nyloc nuts with a small ammount of super glue, and used washers on the van roof side, also with some super glue.
Double-sided tape holds the bracket in place ready for the screws.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!