MakerWorld
Other Art Models
Model downloaden
Scarecrow in a Hat
62
Downloads
46
Likes
32
Makes
Can a scarecrow be cute? This one can! I used an orange-yellow hue for this print, but it also looks good in black, blue-gray hue too! Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm Filaments Used:- PLA Kingroon Black Transmission Distance: 0.4- PLA Overture Orange Transmission Distance: 8.4- PLA CC3D Lemon Yellow Transmission Distance: 8- PLA Kingroon White Transmission Distance: 8 Swap Instructions:- Start with Black- At layer #14 (0.72mm) swap to Cream- At layer #23 (1.08mm) swap to Lemon Yellow- At layer #43 (1.88mm) swap to White for the rest.
cyanidesugar publiceert ook op
113 extra modellen op 3 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
