Slicer Discord
scd41 sensor housing – 3D-printbaar model van MakerWorld MakerWorld
Electronics

scd41 sensor housing

3 Downloads
1 Likes
0 Makes
Model downloaden
I designed this sensor housing for the SCD41 from seeedstudio. Since I wanted to mount the sensor hanging from the cable, the cable is fed through from below. I used a M12x1.5 cable gland. The sensor is mounted in the inner part, you can either cut the thread by hand or use spax, wood or sheet metal screws.I followed the installation instructions from sensirion. The sensor is protected from light and direct environmental influences, but has sufficient air circulation in the housing.
Categorie
Electronics
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Wood PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie