Scent Work Odour Imprinter

Elbow shaped scent work odour imprinter, with built in flange for screwing to a plywood base.

You will need to print 1 x Elbow, and whichever of the two filter designs takes your fancy. Screw the elbow to a small square of plywood (I used 12mm) using 4 screws, drop in your odour in its container, and then drop the filter over the top.

Has a generous sized hole so you can reward at source.

Tip (carefully!) upside down to unload, the odour will be retained in the filter.

I printed mine in PLA.

Elbow is printed as-is with the bottom (where the screw holes are) on the build plate. No supports required.


Print the filter part upside down, so that the top surface is on the print bed. Again, no supports needed.