Slicer Discord
Schiit Stack Under-Desk Mount – 3D-Druckmodell von Thingiverse Thingiverse

Schiit Stack Under-Desk Mount

von kaleun96
67 Downloads
48 Likes
1 Makes
Zum Modell
Under-desk mount for a Schiit stack with Introprose connectors. Tested on a Schiit Modi 3+ and a Schiit Magni Heresy, unsure if other or older versions work.

Very stable when assembled, virtually no side-to-side movement and if the correct rubber feet are used in the top of the mount to push against the Magni there is no up-or-down movement of the stack inside the mount.

Important to note that this is made for the Schiit Stack with the [Introprose RCA connector](https://introprose.myshopify.com/products/rca-crossconnect-for-schiit-stack). This connector adds about 2mm height to the stack and separates the Magni and Modi more than if they were resting on top of each other. Rubber feet supplied with the RCA connector are used to fill this gap between the Modi and Magni.

This part may still work for you without the Introprose connector, you will just have a larger gap between the top of the stack and the top of the mount. You can pad this gap with thicker rubber feet or similar.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen