Thingiverse
Sci-Fi Billboards
door Philamilapeed
117
Downloads
85
Likes
1
Makes
Billboards or advertisement screens for use in modern or sci-fi miniatures gaming.
2 versions of each available: pre-supported and un-supported.
The large billboard is designed to accept two different ads on a piece of paper or cardstock, 100mm length x 60mm height.
The smaller, cylindrical billboard is designed to accept two different ads on a piece of paper or cardstock, 50mm height x 40mm length.
Pre-supported prints on an Ender 3 with 0.2mm layer height, 20% infill without any modification necessary. Just remove the rectangular supports with clippers or by hand (they should pop out with minimum fuss) from the screen/ad sections after printing.
Un-supported models are untested; uploaded by request but I can't confirm if they'll print as-is.
2 versions of each available: pre-supported and un-supported.
The large billboard is designed to accept two different ads on a piece of paper or cardstock, 100mm length x 60mm height.
The smaller, cylindrical billboard is designed to accept two different ads on a piece of paper or cardstock, 50mm height x 40mm length.
Pre-supported prints on an Ender 3 with 0.2mm layer height, 20% infill without any modification necessary. Just remove the rectangular supports with clippers or by hand (they should pop out with minimum fuss) from the screen/ad sections after printing.
Un-supported models are untested; uploaded by request but I can't confirm if they'll print as-is.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
