Thingiverse
Scirocco MK1 Bumper Clips
door ldboehm
2
Downloads
3
Likes
0
Makes
This is the clip that attaches the side of the front and rear bumper to the front fender and rear quarter panel
It comes with both the fender clip and the matching nut.
Tip: Add a felt or rubber washer to the inside and outside to protect the body and paint.
For the nut, you may need to scale it up or down a little to get a snug fit.
Print with a hard plastic that does not shrink or warp. Do not use PLA.
Print with high in-fill to ensure proper strength.
I normally print these on their side with the threads facing sideways using supports.
Want it printed professionally, use Shapeways:
Front: https://www.shapeways.com/product/YNPJNLZ2F/front-bumper-bushing-set-for-a-scirocco-mk1?optionId=108407015&li=shops
Rear: https://www.shapeways.com/product/K43QLBSDZ/rear-bumper-bushing-set-for-a-scirocco-mk1?optionId=108406497&li=shops
Find more cool creations on my Scirocco Printed Parts Page
https://www.facebook.com/profile.php?id=100057386022095
It took considerable
It comes with both the fender clip and the matching nut.
Tip: Add a felt or rubber washer to the inside and outside to protect the body and paint.
For the nut, you may need to scale it up or down a little to get a snug fit.
Print with a hard plastic that does not shrink or warp. Do not use PLA.
Print with high in-fill to ensure proper strength.
I normally print these on their side with the threads facing sideways using supports.
Want it printed professionally, use Shapeways:
Front: https://www.shapeways.com/product/YNPJNLZ2F/front-bumper-bushing-set-for-a-scirocco-mk1?optionId=108407015&li=shops
Rear: https://www.shapeways.com/product/K43QLBSDZ/rear-bumper-bushing-set-for-a-scirocco-mk1?optionId=108406497&li=shops
Find more cool creations on my Scirocco Printed Parts Page
https://www.facebook.com/profile.php?id=100057386022095
It took considerable
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!