Scooby Doo pinball - Auto-launch support bracket

Support bracket for Scooby Doo pinball's auto-launch mech. Inspired by pics of an existing mod. Made my own because:
1. I refuse to pay for something Spooky should provide. Enough people have complained.
2. I refuse to pay a mod maker for the same reason
3. Because I can

Print with supports. 40% infill should do it (adjust however you want)

2 - #6x3/8" screws - attach mech to printed part
4 - #6x1/2" screws - attach printed part to playfield wood
Pre-drill holes

Update 12-22-2023
Added striker bracket - fits over the forks that strike the ball, friction fit. This does a few things:
- prevents the forks from bending in or out from their factory position
- strikes the ball evenly
- allows the auto-launch coil power to decrease. Lowest I could successfully launch a ball was 51% power. Factory setting was 80% power. So any place in between would be sufficient. I settled on 65%