Scope Protector mount - Romeo 4T Red Dot

Mounts for scope protector disks (e.g. polycarbonate) to be used e.g. for airsoft. The inserted disks will need to be between 22.5mm-26mm in diameter, required thickness for sufficient protection depends on your field limits & quality of material.

Designed for the Evolution Gear ROMEO 4T (Sig ROMEO4T-PRO clone). It slots into the front lens cover mount.

This is intended to be printed in flexible material (e.g. TPU 95A) to both improve impact resistance & allow it to be easily replaceable. Printing it in a rigid material may require destroying the mount to remove it.

Ignore the version numbers, there is no relevant difference.

To install:
* Remove front lenscover & ring
* Reattach the aluminium screw insert (leaving the ~2.5mm gap)
* Insert polycarbonate disk into the printed mount (use a paper towel or similar to avoid leaving prints on the inside face)
* Slide printed pount + polycarbonate in place until it locks into the 2.5mm gap

To uninstall:
* Lightly squeeze T