Scorpion - Modio Challenge

Figured I'd give one of those Thingiverse challenges a shot.
.
I set this up to be built with all the parts printed in 4 runs (one run per color). I went with a scorpion because It just seemed more organic then the builds with robots. They all seem to be pretty much the same with very little differences between them. I have added a version that is a tad smaller to adhere to the challenge guidelines as I'm reading through the instructions for the challenge and it does say:
.
"The objective of the Contest is to invite Thingiverse Account Holders to create and upload a creative Modio modification (“MakerBot Modio Design”) that fits within a build volume of **10.0L x 10.0w x 12.5h cm**"
.
My Original dimensions were a bit large. I attached the larger version as a Zip file with the 4 trays if you still want to print it larger but the version not in the zip is the proper size for the challenge. I also add two parts to the small version that won't be on the larger version yet as