Scorpion Visor Lever

I had my little lever fall off while trying to close my visor today. This is a quick little design I did to fix mine. It's a bit tight, but it works. From what I've seen, Scorpion uses the same little latch on a handful of helmets. Let me know if the ones I tagged do not work.

To get this in place you have to remove the little latch assembly from the visor. (Single screw on the back) Push the pin out and carefully pull the pieces apart. Slide the 3d printed part in place and put the spring/latch back in place and secure them with the pin. Only one "tooth" from the latch should sit above the 3d print. You can see that in the image.