Thingiverse
Scotch Packaging tape dispenser
door lancealot
358
Downloads
339
Likes
2
Makes
I cleaned up arabon's nice model found here:
http://www.thingiverse.com/thing:24706
There were a few portions of the model that weren't complete which caused the Makerware slicer to produce some strange artifacts.
The holes are patched now and the print looks great!
Edit: I printed arabon's model to find that the outer diameter of the holder was off. I inverted that so it now fits a standard ~76mm (3 in. if you swing that way) roll of packaging tape. The new model is now uploaded in place of the old one.
Edit #2: The teeth easily break off and need to be reworked a bit. Printing with a higher infill or with a stronger filament (nylon) may prevent this from occurring. Suggestions and comments welcome.
http://www.thingiverse.com/thing:24706
There were a few portions of the model that weren't complete which caused the Makerware slicer to produce some strange artifacts.
The holes are patched now and the print looks great!
Edit: I printed arabon's model to find that the outer diameter of the holder was off. I inverted that so it now fits a standard ~76mm (3 in. if you swing that way) roll of packaging tape. The new model is now uploaded in place of the old one.
Edit #2: The teeth easily break off and need to be reworked a bit. Printing with a higher infill or with a stronger filament (nylon) may prevent this from occurring. Suggestions and comments welcome.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!