Scoutfly Cage

I've been begun work on a full Monster Hunter cosplay and started with a scoutfly lantern from Monster Hunter: World and Monster Hunter: Wilds. The lantern is three pieces with a fourth piece to assist in bending a 3mm diameter wire for use as the handle (I used aluminum). I recommend printing each piece individually since moving between multiple parts while printing lowers the quality a little. In the provided profile I have the cage oriented at an angle which works and uses significantly less supports, however I personally like printing it with the open end facing upwards and turning on ironing so that at least some of the surfaces come out much smoother. The fairy lights I used are powered by a 2 pack of CR2032 batteries so I assume any similarly sized pack will fit into the Inner Cage. While personally I think it's strange, there is a strip of leather going around the outside of the lantern in game so the cylindrical flat area of the Base Outer is sized to glue on a 2.2mm/1