Screen Door Handle With Hex Design

This replacement knob should fit in place of other knobs that fit onto a square post 8.2mm wide.

I created this to replace a knob that was too deep and started interfering with my deadbolt when I installed a different deadbolt that protruded farther from the surface of my door. This is the third version, after people kept breaking the previous design. This one is *sturdy*. (You should still print it at 100% infill, though.)

Printed on my Prusa i3 Mkii, ABS plastic at 100% infill, 0.2mm layer height, no raft, no supports.