Thingiverse
Screen Stand
von steve-walsh18
5
Downloads
9
Likes
0
Makes
Simple screen stand. I designed it for my portable computer monitor but should work on some tablets.
You will need to print two (one for each side) and although untested, there is also a 1 cm riser to raise the height if needed and you can print as many of these as needed to achieve the desired height.
Printed with 20% infill but if want stand to be heavier, increase as necessary.
Supports are needed for the connections but they were a bit of a pain to remove. This could have been an issue with my settings as I am very new to 3D printing.
You will need to print two (one for each side) and although untested, there is also a 1 cm riser to raise the height if needed and you can print as many of these as needed to achieve the desired height.
Printed with 20% infill but if want stand to be heavier, increase as necessary.
Supports are needed for the connections but they were a bit of a pain to remove. This could have been an issue with my settings as I am very new to 3D printing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
