Screw Bit Case - No Lid
von azzajess
16
Downloads
17
Likes
0
Makes
This is a simply remix of MortenGuldager Screw bit case without the lid and the thread to reduce the amount of filament/time used if lid is not being used.
I also reduced the rim a little as no lid was needed.
Printed Fine at 3.2mm
I also reduced the rim a little as no lid was needed.
Printed Fine at 3.2mm
azzajess veröffentlicht auch auf
21 zusätzliche Modelle auf 3 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!