Slicer Discord
Screw Fixed Double Door Hook – 3D-Druckmodell von MakerWorld MakerWorld
Other House Models

Screw Fixed Double Door Hook

24 Downloads
7 Likes
14 Makes
Zum Modell
This double door hook is a little more trouble to install than most, but it also won't interfere with the operation of the door. I find that many over-the-door hooks can make a door difficult or impossible to completely close. This one installs by driving one screw in the top, so it won't damage the face of the door. Since it's screwed in place, it also won't rattle around or move when you lift an item off the hook. I've included six sizes which should work for most doors. The top piece that fits into the gap at the top of the door is available in either 3mm or 4mm thickness. The depth of that piece is available in three sizes, at 24mm, 28mm and 32mm. If your door is thicker, the 32mm version will still work fine. Check out my standard door hook here.
Kategorie
Other House Models
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

zentenro veröffentlicht auch auf

72 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen