Thingiverse
Screw M8x10mm
von Hammerfrog
33
Downloads
36
Likes
0
Makes
Made this for the Nano Vise V2 https://www.thingiverse.com/thing:5178901 balljoint
since I did not have that kinda screw laying around.
It is a tight fit, but it works.
Printed on Ender 5 using Cura.
Material: PLA
Layer height: 0.12
Wall line count: 3
Top/ bottom layers: 3
infill: 50%
since I did not have that kinda screw laying around.
It is a tight fit, but it works.
Printed on Ender 5 using Cura.
Material: PLA
Layer height: 0.12
Wall line count: 3
Top/ bottom layers: 3
infill: 50%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
