Thingiverse
Screw Terminal Block
by CthulhuLabs
31
Downloads
14
Likes
0
Makes
I needed a screw terminal block for distributing power to my fans. Figured I could just design and print one.
Required hardware:
6x M3 8mm bolts
12x M3 metal washers
3x 20cm lengths of 18guage wire
Smaller gauges of wire work, but will limit the amount of current you can pass through this terminal block. If you are placing this directly on plastic you don't really need plate 1. Its mainly there as an electrical insulator on metal surfaces.
Required hardware:
6x M3 8mm bolts
12x M3 metal washers
3x 20cm lengths of 18guage wire
Smaller gauges of wire work, but will limit the amount of current you can pass through this terminal block. If you are placing this directly on plastic you don't really need plate 1. Its mainly there as an electrical insulator on metal surfaces.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
