Screwdriver - Dovetail SYSTEM

Screwdriver-Holder for Dovetail SYSTEM This “Screwdriver-Holder” is part of my Dovetail-SYSTEM. You can find it via the following link:→ https://makerworld.com/de/models/1651472-dovetail-system-for-skadis-or-screw-on-rail#profileId-1745991 Everything else is described there. Information about the Screwdriver-Holder:This holder can be adapted to fit your tool. Use the modeler to do so. As shown in the pictures above, adjust the "holes" accordingly.→ Allow for some tolerance: if your screwdriver shaft is 5 mm wide, make the hole 5.5 or 6 mm. The same applies to the large diameter. This allows the holder to fit your screwdriver. You can also adjust the collar, I used 22 mm for all screwdrivers. The "tolerance" tab is preset to 0.1 mm, which allows enough space for the holder to easily fit into the main rail.→ If you need different tolerances, you can adjust them in the modeler. Increasing the value generates more air. As you can see in the pictures, spacers are also needed