SculpFun S9 limit switch mount

remixed a single support mount for both axes, that fit perfectly UNDER the Vslot Profile right close to the lower left feet (control board one), and under the left side of X-axe.
I used the same Ender 3 limit switch: https://t.ly/Pkll

for mounting you have to assemble the mount and the peg (separate for better printing), use an M5 t-nut

X AXE
I used an old mouse usb cable as a wire (logitech are the thinnest, and they can pass throug a rubber v-slot cover like this: https://t.ly/tK_e on the back side of the axe

Y AXE
to better manage cables, i removed the upper right screw that hold the mainboard cover, enlarged the hole with an 8mm drill bit and used the same usb cable for wiring