Thingiverse
Sculpfun S9 Mounting feet
von Nunu57
39
Downloads
21
Likes
0
Makes
Mounting feet for Sculpfun S9.
It provides an additional screw to block the Laser Engraver on the feet.
Feet increase high of engraver of 20mm (size used by Ortur honeycomb support https://amz.run/5Ba5 )
Needed materials:
- 16 x : M4 nuts
- 4 x : M4 x 10mm screws (to block the laser engraver)
- 12 x : M4 x (10 + width of the support) mm screws (in my case 30mm)
It provides an additional screw to block the Laser Engraver on the feet.
Feet increase high of engraver of 20mm (size used by Ortur honeycomb support https://amz.run/5Ba5 )
Needed materials:
- 16 x : M4 nuts
- 4 x : M4 x 10mm screws (to block the laser engraver)
- 12 x : M4 x (10 + width of the support) mm screws (in my case 30mm)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
