Thingiverse
Sculptr Delta - Backing for inductive sensor
door _MathMaker
7
Downloads
11
Likes
0
Makes
This thing was created to adapt an inductive sensor on the main fan of the Sculptr Delta printer.
You just have to remove the two left screws of the main fan and insert it. To hold it, use the fan's screws, you normally have space to install it.
The hole for the induction sensor is in M8. This piece is adaptable for a 30x30mm fan.
Have fun!
Edit 23/02/2017 : I added a new version adapted for the nut of the sensor.
You just have to remove the two left screws of the main fan and insert it. To hold it, use the fan's screws, you normally have space to install it.
The hole for the induction sensor is in M8. This piece is adaptable for a 30x30mm fan.
Have fun!
Edit 23/02/2017 : I added a new version adapted for the nut of the sensor.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!