SCX10 Pro Cab Only Bed

This Bed is made for the Axial Scx10 Pro Cab only Build. Lay Bed in place and drill 4 1/8 holes into the bed floor directly above the stock chassis brace in the rear. screw in 3mm screws to mount bed to truck. Next lay cab on truck and mark the 2 holes against the back of the body with a sharpie and ream holes. From the inside of the cab, push the included body mount posts through the back of the body. On the outside of the body mark the small holes and ream those out to mount with 3mm screws/nuts. When complete the body posts off the back of the cab will slide into the holes in the front of the bed and can be held in with body clips. Pics are included to make this more understandable.

This bed is designed to fit 4 5mm LEDs and an RCPLATESHOP plate on the back.

Dont forget to come like & support my FB Page: Scaler Lab RC

I print the bed flat to the build plate with supports touching the build plate only. The body mount i print with no supports.