MakerWorld
Other Props & Cosplays
Model downloaden
Scythe Topper
18
Downloads
7
Likes
8
Makes
I created a sythe topper for a 20mm wooden dowel. I am going to stain the dowel so that it is less pale. I printed the scythe upright to have a tree support in the spot where the dowel goes. I made this prop for a demon mannequin I am making for a Halloween decoration. Could be used for a costume prop. Please be careful with any sharp edges. I did not make them as sharp as a real scythe but there is potential for injury if care is not taken.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
