Thingiverse
SD Card box
by rootadmin
6
Downloads
21
Likes
0
Makes
Lid tolerance is 0.05mm, depending on your printer quality, if the closing is too tight, you can use some sanding paper to adjust the tightness.
Material: PLA
No support
No Adhesion
Resolution: Tested with 0.2mm / 0.15mm - both did OK
Infill Density: 10%
Overall material: ~40gr (0.2mm Infill)
Material: PLA
No support
No Adhesion
Resolution: Tested with 0.2mm / 0.15mm - both did OK
Infill Density: 10%
Overall material: ~40gr (0.2mm Infill)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
