Thingiverse
SD Card Case
door ImAThingsGuy
71
Downloads
56
Likes
1
Makes
I know it may not be the most ergonomic design but I was very happy with the result.
There is a bit of tolerance in each cell slot so that you can glue in a small piece of foam, this allows an SD card to have a kind of "soft pressure" hold that is a lot nicer than a lose fit or a fit that causes the SD and print to grind together.
There is a bit of tolerance in each cell slot so that you can glue in a small piece of foam, this allows an SD card to have a kind of "soft pressure" hold that is a lot nicer than a lose fit or a fit that causes the SD and print to grind together.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
