Thingiverse
SD Card Holder - 10 Stack
door kingkappa
2
Downloads
0
Likes
0
Makes
A 10 stack SD Card Holder. Created in Freecad. 3D print with slots facing upwards. I use a RAFT and tree support. You may need to run a needle file through a couple of the slots to clean them up, but minimal manual labour will be required if any.
The latest upload 1014.stl is a rescale to 1.014 in size. No filing required.
Covers for both sizes of the SD Card Holder have been added.
The latest upload 1014.stl is a rescale to 1.014 in size. No filing required.
Covers for both sizes of the SD Card Holder have been added.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!