Thingiverse
SD Card Holder
von bartoaster
11
Downloads
8
Likes
1
Makes
SD-card holder for 20 cards.
*** Important ***
the lid is held by two 6mm * 3mm magnets (6mm diameter, 3mm height or smaller)
you will need glue to keep them in place.
*** Important ***
the lid is held by two 6mm * 3mm magnets (6mm diameter, 3mm height or smaller)
you will need glue to keep them in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
