Thingiverse
SD Card Holder
5
Downloads
2
Likes
0
Makes
This is a remix of the SD card holder by n2b8. The model was made from scratch with the overall dimensions close to the original and keeping 6 slots for SD cards.
There is a patterned surface to the holder which somewhat disguises the layering and seam of a print. We print these at both 0.2 and 0.125 layer height.
To get a good matching finish to the top and bottom we print on a textured PEI build plate.
There is a patterned surface to the holder which somewhat disguises the layering and seam of a print. We print these at both 0.2 and 0.125 layer height.
To get a good matching finish to the top and bottom we print on a textured PEI build plate.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!