Slicer Discord
SD-Card Slider Case – 3D-Druckmodell von MakerWorld MakerWorld
Organizers

SD-Card Slider Case

107 Downloads
35 Likes
40 Makes
Zum Modell
This is my sliding case for SD cards. it is doublesided with lids labeled "Full" and “Ready For Use”. There is a blank lid for those that wish.I wanted a slim case for my camerabag with 2 compartments to be able to separate the empty cards from the full ones. So I designed this slim sliding case that measures 12.8x34.8x132mm. There is 3 versions of the sliding lids with different labels,Ready for use, Full and a blank version. This model does require assembly and glue is required For gluing the middle parts together to form the doublesided housing.I used Loctite Super Glue Gel. wich I found works well with PLA.During assembly of the housing I recommend using 2 short pieces of 1.75mm filament in the guide holes for easy alignment. Hardware needed1x Socketcap M3x301x Spring L25mm x ID3,4mm x OD4,3mm (you can easily find this in an old pen)
Kategorie
Organizers
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen