Thingiverse
SD-Card Tower
von Souko
55
Downloads
40
Likes
1
Makes
A small SD-Card Tower for 11 standard-SD-cards.
Just print 2 pieces of "Plate.stl" and one of each other part.
Just clip together or juse a small dot of glue.
EDIT: Added "Plate_longer_holes.stl" - the Holes for the side-Plates are 1 mm longer, but not wider for easier assembly. The rear-hole is 0.5 mm wider.
Just print 2 pieces of "Plate.stl" and one of each other part.
Just clip together or juse a small dot of glue.
EDIT: Added "Plate_longer_holes.stl" - the Holes for the side-Plates are 1 mm longer, but not wider for easier assembly. The rear-hole is 0.5 mm wider.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!